
Re: Vertical wire supported by metal mast
I use an inverted L on 160 which is supported from a versatower at about 45ft, the vertical section of the inverted L is positioned around 10ft away from the base of the tower rising up at an angle towards the tower where it held up about 2ft away from the rotator cage, the end of horizontal section is supported at 30ft or so. I get decent results with it, I've not tried it with the vertical section running parallel to the tower so can't say if there is any difference in performance.
This is how I feed it, I have 2 tappings on the coil if I want to work lower on the band and just swap them over manually.
